Apricorn EZ Upgrade 3.0 - SATA Notebook Hard Drive Upgrade Kit with USB 3.0 Connection - Manual (Page 15)

28 29 www.apricorn.com www.apricorn.com
1. Insert Apricorn CD into your CD-ROM drive
2. When the Apricorn CD appears on your desktop, double click to open.
3. Double click on the SuperDuper!.dmg icon
4. This will open the package and mount a drive on your desktop.
5. Open this drive by clicking on the newly created disk icon. The below
window will open on your screen.
6. To install SuperDuper! drag SuperDuper! icon to Applications and run.
7. Follow the instructions included on the SuperDuper! User’s Guide to
setup.
SuperDuper! Backup Software for Mac After the Clone
Once the transfer is complete, you are ready to install your new hard drive.
Turn off the laptop and disconnect the EZ Upgrade’s data and power cables.
Disconnect the Laptop’s AC adapter, and remove the laptop battery to
reduce the risk of damage or electrical shock.
Consult the Computer’s User Manual for instructions on how to remove the
original hard drive from your computer. Some laptops may have the disk
drive mounted under a cover. Other laptops may have the original drive
mounted inside a “drive caddy” to allow quick removal of the drive from the
laptop (although it might appear that the drive caddy and the EZ Upgrade
drive are not the same, once you open-up the drive caddy you will find an
identical hard drive inside). If the hard drive is mounted inside a drive caddy,
carefully remove the hard drive from the caddy. Be careful not to damage
the hard drive pins or any custom connectors. The hard drive may have a
connector covering the pins. Please take note of all connectors and their
orientation.
Remove the original drive and replace it with the new one. If the laptop drive
is mounted inside a caddy, install the new drive into the caddy and then
insert the assembled caddy back into the computer. For specific instructions,
please refer to your computer’s User Manual or manufactures’ web site.
Boot the laptop from your new hard drive. The new hard drive should boot up
as though it was the old drive.
Using the EZ Upgrade as a external backup drive
WARNING: Formatting a Hard Drive will erase everything on the drive!
Please do not reformat the original drive until you have verified that your new
drive is working properly.
After successfully copying everything over to your new drive, the EZ Upgrade
enclosure can be used as an external USB backup drive. At this point we
recommend that you wait until you are certain that your new hard drive is
working properly. When you are certain that your system is working properly,
follow these basic steps listed below to use the EZ Upgrade as a backup
drive.
1. Install the old hard drive into the EZ Upgrade universal. (Please refer
to Page 6 for hard drive installation instructions.)
2. Connect the EZ Upgrade to your system.
3. Reformat the old hard drive (See FAQ #4 on page 29 of this manual for
a link to the Microsoft website with complete instructions for both XP,
Vista & 7)
4. Follow instructions in the appropriate section of this manual for Cloning
to create a full bootable backup or just use the drive for external storage.