Apricorn Aegis NetDock - Mac Edition - Manual (Page 3)

3
www.apricorn.com
Whether you received your Aegis NetDock
with or without a hard drive installed, the
easy open design means that you can change
out your hard drive in a snap.
Please make sure that the Aegis NetDock
is not connected to the AC Adapter or your
computer when attempting the below.
Step 3
Insert the hard drive by sliding the
drive to meet with the SATA hard
drive connector
Step 2
Turn the NetDock over and slide the
top case away from the bottom case as
shown
Step 5
Once the hard drive is secured, slide the
top case back into place
Step 6
Once you have replaced the top case, turn
the NetDock over and replace the screw
Step 1
Remove the single screw found
on the back side of the case
Important hard drive handling info
Discharge static electricity by •
touching a grounded bare metal
surface or grounding straps before
handling the hard drive
Install hard drive on a non-
•
conductive or anti-static surface
Avoid direct contact with the circuit
•
card on the hard drive
Hard Drive Installation
Step 4
Secure the hard drive using the
included screws as shown below
Hard
Drive
Hard
Drive