B&G V90 VHF Radio - Manual (Page 16)

16 |
Installation | V90 Installation Manual
Installing a wireless handset cradle
The wireless handset has a cradle that incorporates inductive
charging for the rechargeable battery.
1. Choose a suitable location that provides sufficient room for the
handset to fit securely in the charging cradle.
2. Hold the cradle at the chosen location and mark the positions of the
fastening holes and the wire hole onto the mounting surface.
3. Drill the holes where marked with a drill bit suited to the selected
mounting fasteners.
4. Feed the wire through the wire hole. If mounting outside, apply a
suitable sealant or fit a cable gland.
5. Attach the handset cradle using selftapping screws or pan head
machine screws, see below.
6. Connect the wire to a 12 VDC source via a 1 A fuse:
• Red wire to 12 VDC positive
• Black wire to negative.
Fastenings
• Top holes
2 x M3.5 x 28 mm machine screws,
nuts and washers, or
2 x M3.5 selftapping screws
• Bottom hole
1 x M3 x 40 mm machine screw, nut
and washers, or
1 x 3 mm x 40 mm selftapping screw.