B&G Network Compass - Manual (Page 8)

NETWORK COMPASS USER MANUAL
SETTING THE COURSE MEMORIES
Whilst in Off Course mode the two course memories may be set. The currently active
course memory is shown by the legend CRSE1 or CRSE2.
Pressing the LOCK key brings up the current course memory (e.g. CRSE1) which will
flash on the display. Pressing LOCK twice displays the other course memory (CRSE2).
Whilst the setting is displayed it can be adjusted by using the and keys (normally
the MODE and TIMER keys). The display will revert to normal operation five seconds
after the last key is pressed.
Alternatively the displayed course memory can be reset by sailing on a heading then
depressing the LOCK key for two seconds. The current course will then be stored in the
selected course memory.
In Head/Lift mode the same methods can be used to set the PORT and STBD heading
memories (see THE HEAD/LIFT DISPLAY).
If a remote button, shown below, is fitted as an option then this performs the same
functions as the LOCK key.
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
30 20 10 30 20 10
OFFCOURSE
STBD
CRSE 2
STEER
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
30 20 10 30 20 10
OFFCOURSE
PORT
CRSE 1
STEER
The Optional Remote Button with 15m cable
8