B&G Network Wind - Manual (Page 5)

SELECTING THE DISPLAY MODE
The Network WIND unit has three operating modes.
The correct mode must be selected for your Network
system to operate correctly.
tu Unit mode, the unit uses and displays wind data from a
wind sensor connected directly into the display unit. Your unit
is supplied in this mode.
tr
Repeater mode, the unit operates as a wind repeater
using data from the system network.
td Demo mode, the unit runs an internal demonstration
program.
Press SETUP key 4 times
to display current mode. Press ENTER key if the
mode needs to be
changed. The display
flashes. Use ¿ or À key to
change the mode. Press ENTER key to
memorise the new mode. After
30 secs the display will revert
to previously selected display.
HB-0502-03 5