Baseline Systems C Cabinet User Manual
Page 2
1-866-294-5847
Rev 11.1.2012
www.baselinesystems.com
Enclosure Electrical Installation
Note: Baseline recommends that you consult or hire a licensed electrician for these
connections.
1. Turn AC power off at the source, and verify that it is off.
2. Remove the screws from the cover of the conduit body, and then remove the cover.
3. Loosen the screw on the grounding lug and route a bare 6 AWG (4.11 mm) earth ground
wire into the grounding lug, and then tighten the screw to secure the ground wire. Do not
overtighten.
4. Connect the enclosure power leads to facility power.
5. Power up the BaseStation controller and review the status LEDs on the BaseStation front
panel.
Follow Local Electrical Codes and Practices
Baseline C Cabinet
Wall Mount Enclosure
Installation Guide