Baseline Systems BaseManager 2.0 VM - Manual (Page 8)

BaseManager 2.0 VM Server Configuration Guide
 If you want to assign a static IP address, press TAB to move to the Use DHCP field, and
then press SPACEBAR to remove the * from the field. Press TAB to move to the
additional fields, and complete those fields as you go. Press TAB to select the Ok button,
and then press ENTER. Continue to step 6.
6. When the Select a Device screen displays again, press TAB to select the Save button, and then
press ENTER.
7. When the Select Action screen displays again, press TAB to select the Save& Quit button, and
then press ENTER.
If the server connectivity test is successful, the following message displays:
Congratulations! Your IP setup was successful!
Note: If the connectivity test fails, you will return to the IP Setup step.
8. Press any key to continue. The following message displays:
The web server has been successfully configured
9. Press any key to continue. The following message displays:
Your BaseManager 2.0 Server Setup is complete!
8. Type Exit, and then press ENTER. The “hostname” login prompt displays in the
configuration interface.
10. Leave the BaseManager server hardware powered up and connected by Ethernet.
4