Baseline Systems Ethernet Radio - Manual (Page 3)

Page i
Table of Contents
Section 1 Configuring the Radios ................................................................................. 1
Before You Begin ...................................................................................................................... 1
Overview of the Steps .............................................................................................................. 1
Step 1 – Ask Your Network Administrator for LAN Network Settings ............................................ 2
Step 2 – Complete the Ethernet Radio Configuration Worksheet ................................................. 2
Step 3 – Install the Radio Equipment and Antennas ...................................................................... 2
Step 4 – Verify Radio Communication over the Stand-Alone Network .......................................... 3
Step 5 – Download the Discovery Server Executable to the Laptop Computer ............................. 3
Step 6 – Configure the Settings on the Ethernet Radios ................................................................ 3
Change the Default IP Address to the Static IP Address for the LAN ........................................ 3
Change Additional Radio Settings ............................................................................................ 5
Step 7 – Verify that the Controllers Are Connected to BaseManager ............................................ 6
Section 2 Adding a Repeater ........................................................................................ 7
Overview of the Steps .............................................................................................................. 7
Step 1 – Map Out the Subnet IDs for the Network ........................................................................ 7
Step 2 – Install the Repeater Ethernet Radio at the Site ................................................................ 8
Step 3 – Find the IP Addresses for the Radios ............................................................................... 9
Stand-Alone Network Instructions ........................................................................................... 9
Find the IP Address of the Repeater Ethernet Radio........................................................... 9
Change the Computer’s IP Address to Connect to the Stand-Alone Network ................... 10
Step 4 – Configure the Settings for the Endpoint that is Called through the Repeater................ 10
Step 5 – Configure the Settings for All Other Endpoints in the Network ..................................... 11
Step 6 – Configure the Settings for the Repeater ........................................................................ 12
Step 7 – Configure the Settings for the Gateway ......................................................................... 12
Step 8 – Verify that the Controllers Are Connected to BaseManager .......................................... 13
Section 3 Using the Configuration Web Server ...........................................................15
Connecting to the Configuration Web Server .............................................................................. 15
Ethernet Radio Settings Reference .............................................................................................. 16
IP Setup Settings .................................................................................................................... 16
IP Address / Subnet Mask / Default Gateway Fields ......................................................... 16