Baseline Systems BL-FLOWSTN-P FlowStation Module - Manual (Page 4)

BL-FLOWSTN-P FlowStation Module
Installation Guide
1-866-294-5847
Rev 9.5.2014
ww.baselinesystems.com
Attaching the Ethernet Cables
1. Remove the two Ethernet cables from
their packaging.
2. Plug one end of each cable into a port
on the Ethernet switch.
3. Route one of the cables through the
top of the pedestal and plug the end
into the Ethernet port on the back of
the BaseStation 3200 display board.
4. Plug the other Ethernet cable into the
Ethernet port on the back of the
FlowStation module.
Note: The third port is reserved for the
network connection.
Turning the Power On
1. Remove the screw that fastens the key to the box.
IMPORTANT! Put the screw in a safe place because you will need to replace it later.
2. Insert the key into the on/off switch and press it up to turn the power on.
3. Remove the key and reattach it with the screw to prevent it from being misplaced.
4. Verify that the Power LED is illuminated on the BaseStation 3200 faceplate.
5. Turn the BaseStation 3200 dial to the Run position.
6. Refer to the FlowStation Quick Start Guide and the FlowStation User Manual for configuration
instructions.
IMPORTANT REMINDER!
Make sure that the shared flow biCoder (BL-3200UPG-SF) has been attached to the two-wire
path of the BaseStation 3200. Refer to the Shared Flow biCoder Installation Guide for instructions.