Carrier Access BROADway System 770-0125-AB - Manual (Page 39)

BROADway - Release 4.00 2-23
Installation
Installing the BSP200 Line Interface Card
If the card failure sequence is displayed, remove the card and re-insert it into the chassis. If the card
failure sequence is still displayed, then replace the card.
Line status (per port):
INTERFACE Red LED
(Bottom) INTERFACE Green
LED (Top)
Status
Off Off The card is not configured, or
alarm reporting is disabled on the
interface
Off On Interface operating normally
Off Blinking Interface performing a diagnostic
test
On Off Interface failure (LOS, OOF, AIS)
Blinking Off Yellow alarm (RAI)
On On Interface initializing during system
power up