Calyx AL - 2 -Way Powered Speaker System - Manual (Page 8)

Calyx AL 2-Way Powered Speaker System
Digital & Analog Co., Ltd. (Rev. 1.0) -8-
◆ Connection
Step 1. SPEAKER WIRE CONNECTION
Connect the RED (+) and BLACK (-) terminals from the left speaker to the corresponding terminals
on the right speaker using a speaker wire. Be sure to match the red-colored side of the speaker wire
with the RED (+) terminals and the black-colored side to the BLACK (-) terminals on each speaker.
Note : As the Calyx AL Speaker system is self-powered, do not connect the speaker terminals to the
speaker outputs of a stereo receiver.
Detailed procedure :
● Remove the pre-cut insulation on the end of the speaker wire and twist the exposed wire strands
2-3times.
● Use your thumb and finger to unscrew the binding post connector.
● Insert each speaker wire into the holes on the side of binding post connector.
● Retighten the binding posts. The stripped wire portion should be secured firmly in the connector.
● Repeat the procedure to connect the other end of the speaker wire to the other speaker. Be sure
to match the wire color to the same terminal color on each speaker. Also make sure that none of
the speaker wire strands have come in contact with an adjoining terminal.
Step 2. POWER CABLE CONNECTION
Verify that the voltage selector switch is set to the proper voltage for your area.
Connect the power cord into the left speaker and the other end into the wall outlet.
Step 1
Step 2