Installing the fan assembly – Cisco 5500 User Manual
Page 16
7-16
Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide
OL-0542-06
Chapter 7 Maintaining the Cisco Catalyst 5500 Multiswitch Router
Replacing Hardware Components
Note
The fan assembly is designed to be removed and replaced while the system is operating without
presenting an electrical hazard or damage to the system.
Step 1
Locate the fan assembly to the left of the card cage (see
Step 2
Loosen the two captive installation screws by turning them counterclockwise.
Step 3
Grasp the fan assembly with both hands and pull it outward, joggling it if necessary to unseat it from the
backplane. Pull it clear of the chassis and place it in a safe location.
Installing the Fan Assembly
Perform the following steps to install the new fan assembly:
Step 1
Hold the fan assembly with the fans facing to the right.
Step 2
Place the fan assembly into the front chassis cavity so that it rests on the chassis, and then lift the fan
assembly up slightly, aligning the top and bottom guides.
Step 3
Push the fan assembly into the chassis until the captive installation screws meet the chassis.
Step 4
Tighten the captive installation screws by turning them clockwise.
Figure 7-13 Cisco Catalyst 5500 Chassis Fan Assembly
H10647
SUPERVISOR ENGINE
SY
ST
EM
ST
AT
US
FA
N
AC
TIV
E
M
DI X
M
II
M
DI X
MII
RESET
CO
NSO
LE
100%
1%
SW
ITC
H
LO
G
PS2
10
0 M
bps
LINK
100 M
bps
LINK
PO
RT 1
PS1
PO
RT 2
SUPERVISOR ENGINE
SY
ST
EM
ST
AT
US
FAN
ACTIVE
MDI X
MII
MDI X
MII
RESET
CONSOLE
100%
1%
SWITCH
LOG
PS2
100 Mbps
LINK
100 Mbps
LINK
PORT 1
PS1
PORT 2