CTEK M4400E SkyRouter - Manual (Page 9)

Part Number 91-601-01
Release 1.00
6
3 Start Up
Warning – You must connect antennas to the SMA style antenna connectors on the SkyRouter before turning it
on. Failure to do this could result in erratic start up behavior and could possibly damage the unit.
Note – The 4200 SkyRouter ships from the factory with its DHCP server enabled. The Default Gateway address
for the unit is 192.168.1.10. The address of the web based administration is also 192.168.1.10. After you have
activated your unit on the wireless network it WILL NOT have a DNS address, meaning that public Internet web
access will not work. To load DNS values go to the Ethernet Interface screen, select “Acquire From Wireless
Network” and press the update button. At this point the Primary and Secondary DNS addresses in the Ethernet
Interface screen will be populated with the DNS addresses provided by your wireless network. As a last step
restart both the SkyRouter and the connected PC.
3.1 Power
Before starting connect the supplied 12VDC power adapter to the power connector described in Section 3. The adapter
supplied with your SkyRouter is suitable for use with 120VAC 60-hertz wall power. If you need a different power solution
contact Ctek.
3.2 Connecting The Antenna
The antennas supplied with each SkyRouter should be attached to the SMA style antenna connectors described in
section 3. The antenna must be connected before powering the unit on.
3.3 Connecting to the Ethernet Port – Administrative Connection
For a direct Ethernet connection between a PC connect to any of the Ethernet ports using a standard or reverse Ethernet
cable. For initial configuration and administration with a PC or workstation Ctek recommends that the PC be set to obtain
an IP address and obtain a DNS address automatically. For Windows PCs make the following settings under the
networking control panel
LAN (Ethernet) Connections - Windows