Sony PMW-EX3 - Manual (Page 83)

Shot Transition 83
Record
ing
When “Rec Link” is “Shot-A” or “Shot-
B,” the camcorder automatically performs
the shot transition to the camera settings
registered to Shot A or Shot B, respectively.
You need not press the button.
Notes
• You cannot return to the status in step 1 once
after you start the shot transition. If the status
must be resumed, register it as a shot.
• When you perform recording on an external
device connected via the i.LINK(HDV)
connector in synchronization with REC
START/STOP operations on this camcorder,
recording start on the external device and shot-
transition start may not be synchronized even if
“Rec Link” has been set to “Shot-A” or “Shot-
B,” depending on the performance of the
external device.
Making a transition from Shot A to Shot B
When “Rec Link” is set to “Off” or “Shot-B,” a
shot transition from Shot A to Shot B is possible.
1
Press the MODE button to display
“Check” in the shot-transition
operation area.
2
Press the A button.
The picture is adjusted according to the
camera settings registered for Shot A.
3
Press the MODE button to display
“Execute” in the shot-transition
operation area.
4
Press the REC START/STOP button.
Recording begins with the camera settings
registered for Shot A.
5
When “Rec Link” is “Off,” press the B
button when you wish to start the shot
transition.
When “Rec Link” is “Shot-B,” the
camcorder automatically performs the shot
transition to the camera settings registered
for Shot B. It is not necessary to press the B
button.
Making a transition from Shot B to Shot A
When “Rec Link” is set to “Off” or “Shot-A,” a
shot transition from Shot B to Shot A is possible.
1
Press the MODE button to display
“Check” in the shot-transition
operation area.
2
Press the B button.
The picture is adjusted according to the
camera settings registered for Shot B.
3
Press the MODE button to display
“Execute” in the shot-transition
operation area.
4
Press the REC START/STOP button.
Recording begins with the camera settings
registered for Shot B.
5
When “Rec Link” is “Off,” press the A
button when you wish to start the shot
transition.
When “Rec Link” is “Shot-A,” the
camcorder automatically performs the shot
transition to the camera settings registered
for Shot A. It is not necessary to press the A
button.
Ending recording
When recording is completed, press the REC
START/STOP button.
To cancel recording while a transition is in
progress
If you press the REC START/STOP button
during recording, the recording stops, even when
a shot transition is in progress.
The E-E picture of the settings where the
recording stops is displayed.
Releasing a Shot Transition
Press the MODE button so that the button
indicator goes dark.
The viewfinder screen resumes the normal
condition.