Crown Audio 1202 & 2402 - Manual (Page 17)

page 17
MA Series Power Amplifiers
Operation Manual
For PIP2s featuring ribbon cable connectors,
simply locate the two connectors on the under-
side of the PIP circuit board, then connect the
two input ribbon cables coming from the ampli-
fier (see Figure 5.3). Both ribbon cables should
run smoothly from the amplifier to the PIP card.
Insert the PIP and attached cables into the PIP
opening in the back of the amplfier, then screw
securely into place.
WARNING: Disconnect power to the
amplifier when installing or removing a
PIP module.