Peration, Ready tools™ cleaning with attachments – Bissell 1623E User Manual
Page 9
9
w w w . b i s s e l l . c o m
Ready Tools™ cleaning with attachments
Your deep cleaner comes equipped with a hose
and at least one attachment for cleaning stairs,
upholstery, and more.
Important! If using the machine to clean
upholstery, check upholstery tags.
1.
Check manufacturer’s tag before cleaning.
“W” or “WS” on the tag means you can use
your PowerSteamer. If the tag is coded with
“X” or “S” (with a diagonal strike through),
or says “Dry Clean Only,” do not proceed. Do
not use on velvet or silk. If manufacturer’s
tag is missing or not coded, check with your
furniture dealer.
2.
Check for colorfastness in an inconspicuous
place.
3.
If possible, check upholstery stuffing.
Colored stuffing may bleed through fabric
when wet.
4.
Plan activities to give upholstery time to dry.
5.
Vacuum thoroughly to pick up loose debris and
pet hair. Use a vacuum with a brush attachment
and a crevice tool to clean in fabric folds and tufts.
6.
To begin cleaning with attachments, follow
the instructions on pages 7 for filling the
2-in-1 water tank.
7.
Set the ReadyTools dial to the TOOLS setting.
This will allow spray and suction from the hose.
8.
Attach the desired cleaning tool to the end of
the hose.
9.
Clean by pressing the spray trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the spray trigger to suction
dirty water. Continue to clean in the area,
working in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. It is recommended that you suction clean
water from the tap to rinse out the hose.
12. Before wrapping hose onto tool rack, lift end
of hose and stretch out to ensure all water is
cleared from hose.
O
peration
Adsdfdd ghg bvh
cvbbj jkn hnbj jkvh
gcghhjj
jhffhl kllgh
Manufacturer’s tag
7.
11.
12.
Tip:
To clean with sliding
crevice tool, slide brushes forward
to clean stain, slide back to suction
ug120-4039_1623E_508.indd 9
ug120-4039_1623E_508.indd 9
5/19/08 12:30:00 PM
5/19/08 12:30:00 PM