Bissell 2080 - Manual (Page 8)

Hard floor cleaning
1. Attach hard floor tool to unit.
2. Remove the collection tank (refer to steps 3a
and b in the Maintenance and care section
below)
A. for 1970 series it is necessary to
remove the cross action brush first.
Using your thumbs squeeze the 2
grey tabs towards the outside of the
unit. Push down at the same time and
release the cross action brush.
3. Attach the hard floor tool by hooking it into the
front of the removable nozzle and swinging it
down until the tabs pop into place.
4. Replace the collection tank. Be sure to
attach the 2 latches.
5. Fill solution tank with BISSELL Hard Floor
Solutions™ to FORMULA fill line.
6. Fill solution tank with hot (not boiling) tap
water to the WATER fill line.
7. Follow steps 1-8 in Carpet cleaning section
on page 7 .
When your done
1. Turn power switch OFF.
2. Unplug power cord from outlet.
3. Remove and empty collection tank.
a. Release collection tank latches (1 each
side) by pulling up from bottom of latch
and then out.
b. Carefully lift collection tank from lower body.
c. Carry collection tank to a toilet or sink.
To empty, pour out contents using
opening at back of tank.
d. Rinse collection tank thoroughly.
e. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
3. Clean nozzle window by lifting latch and removing
from machine. Rinse under running water. When
finished replace nozzle and secure with latch.
4. Replace collection tank on lower body and
secure with latches.
M
aintenance and care
8
w w w . b i s s e l l . c o m
CLEAN AFTER EACH USE
Dirty
lift by handle
O
peration
WARnInG:
To reduce the risk of injury
from moving parts and/or
electrical shock, turn power
switch Off and disconnect
plug from electrical outlet
before performing
maintenance or
troubleshooting checks.
a b
c d
4
2080/2090 Series 1970 series
2080 series
OR
3
3