Bissell 9500E - Manual (Page 24)

24 w w w . b i s s e l l . c o m
T
roubleshooting
Cleaner not picking up solution
Possible Causes Remedies
1. ReadyTools dial may be at wrong setting. 1. Set ReadyTools dial to either floor
cleaning or tools setting.
2. 2-in-1 water tank may not be 2. Pick up both the 2-in-1 water tank and
seated properly. formula tank and reseat them so they fit
snugly on the unit.
3. 2-in-1 water tank may not be 3. Check to make sure the "lip" of the
assembled properly. nozzle is securely hooked into the
groove on bottom of Tank (see page 10).
4. Formula or 2-in-1 water tank is empty. 4. Check fluid levels in heavy duty bladder
and bladder and formula tank.
5. 2-in-1 water tank has picked 5. Empty 2-in-1 water tank. Refill heavy
up maximum dirty water and red duty bladder with clean hand hot tap
float door has closed. water and replace.
6. Red float "door" in the tank may 6. Turn the power switch OFF ( O ), allowing
have closed as a result of bumping red float door to release into the open the
an object or moving machine back and position. Turn unit back ON ( I ) to continue
too quickly. cleaning. Be sure your forward and
backward strokes are done at a
slower pace.
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
ug120-4042_9500E.indd 24 ug120-4042_9500E.indd 24 5/7/08 3:37:49 PM 5/7/08 3:37:49 PM