Bissell 25V1 - Manual (Page 8)

w w w . b i s s e l l . c o m
O
perations
8
Power cord usage
1. To use your vacuum, remove the cord
and plug it into an electrical outlet.
For your convenience, there is a quick
release cord wrap for easy cord remov-
al. There is also a cord clip that is part
of the upper cord wrap where you can
attach the cord when vacuuming.
2. When you are finished cleaning, turn
vacuum cleaner off.
3. Unplug power cord by grasping the plug
(NOT the cord) and disconnect from outlet.
4. Loop power cord around cord wraps on
side of vacuum cleaner. Be sure to first
return the quick release cord wrap back
to its original position before wrapping
the cord.
5. Clip molded plug to power cord to secure.
To maximize your cleaning perfor-
mance and extend the life of your
vacuum, it is very important that
you empty your dirt container and
check and clean your filters fre-
quently. Perform the following main-
tenance steps:
1. Empty the dirt container when the dirt
reaches the “Full” line on the container, or
more frequently to prevent overfills. For best
performance, empty after each use.
2. Check the pre-motor filter and post-motor
HEPA media filter* at least once a month,
clean or replace as needed.
3. Replace the post-motor HEPA media fil-
ter* every three to six months.
NOTE: More frequent filter cleaning
may be necessary if you are vacu-
uming new carpet, fine dust, or
have allergy concerns. Follow the
instructions on the following pages
to perform these simple mainte-
nance steps.
Quick Release
Cord Wrap
1.
M
aintenance and care WARNING:
To reduce the risk of electric
shock, turn power switch OFF and
disconnect plug from electrical out-
let before performing maintenance
or troubleshooting checks.
Tip:
To maximize cleaning performance,
check and clean or replace all filters
as suggested.
*The Filter Media, not the vacuum as a whole,
complies with the High Efficiency Particulate Air
(HEPA) filter specification (EN 1822-1:2009).