Bissell Powerforce bagless 75Q1 series - Manual (Page 11)

for any technical queries, please contact
our Technical Helpline at 0845 300 7775 11
Replace drive belt
Use only bISSEll Style 10 replacement belts in
your bISSEll Powerforce bagless.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner (Steps 1-4 of "Check rotating floor brush
and drive belt"), grasp old drive belt and remove
from motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several times
in direction of motor pulley. If properly installed,
drive belt will center itself on rotating brush.
6. Reposition brush cover and replace four
screws. Make sure end of brush cover is
snapped into place.
M
aintenance and care
Brush
Cover