Bissell 82H5E - Manual (Page 10)

10
w w w . b i s s e l l . c o m
M
aintenance and care
Replacing the HEPA media post-motor filter
Use only BISSELL Style 12 HEPA filter in your
BISSELL PowerForce Turbo Bagless.
1. Unplug cleaner from electrical outlet.
2. The HEPA media post-motor filter assists in
the filtration process to return clean air to the
room. It is located behind the door on the front
of the cleaner. When the filter becomes dirty,
open the door, remove the filter and replace.
Note: This filter is not washable and must be
replaced.
3. Replace the door by inserting the tabs on the left
side and snapping the right side into place.
Maintaining the TurboBrush
The TurboBrush should be checked regularly for clogs
or debris wrapping around the brush roll.
1. Remove TurboBrush tool from hose or front of
vacuum.
2. Twist collar so opening is at the top and lift top
cover to remove.
3. Remove brush from belt and clean debris.
4. Replace brush inside belt and place ends into
slots on sides.
5. Reposition top cover, making sure to line up
the inside tab at the front with the opening on
the cover. Twist collar until opening is at the
bottom to lock into place.
WARNING:
To reduce the risk of
injury from moving parts,
turn the power switch OFF
and disconnect plug from
electrical outlet.
HEPA
Media
Post-Motor
Filter
ug110-4049_82H5_1008.indd 10 ug110-4049_82H5_1008.indd 10 10/14/08 2:40:38 PM 10/14/08 2:40:38 PM