Roubleshooting, Please do not return this product to the store, 12 vacuum cleaner won't turn on – Bissell 6355E User Manual

Page 12: Vacuum cleaner won't pick up, Tools won't pick up, Visible dirt escaping from cleaner, Cord will not retract

Advertising
background image

T

roubleshooting

w w w. b i s s e l l . c o m

12

Vacuum cleaner won't turn on

possible causes

Remedies

1. Power cord not plugged in

1. Check electrical plug

2. Blown fuse/tripped breaker

2. Check/replace fuse or reset breaker

3. Damaged cord

3. Refer to a BISSELL authorized service center for repair or

replacement

Vacuum cleaner won't pick up

possible causes

Remedies

1. Incorrect height adjustment

1. Adjust powerfoot to correct height setting

2. Hose not attached to suction opening

2. Grasp quick reach handle and firmly push hose wand onto

the suction opening

3. Crack or hole in hose

3. Check hose and replace if needed

4. Broken or worn drive belt

4. Replace drive belt, see page 10

5. Rotating floor brush bristles worn

5. Replace brush

6. Rotating floor brush jammed

6. Remove brush and clean debris from brush ends

7. Clog in vacuum

7. Follow instructions on page 11 for clearing clogs

8. Dirt container full

8. Empty dirt container

9. Dirt container or upper tank not installed properly

9. Position correctly and lock in place

10. Filters are dirty

10. Check and clean pre-motor and post-motor

filters, see pages 8 & 9

tools won't pick up

possible causes

Remedies

1. Crack or hole in hose

1. Check hose and replace if needed

2. Clog in vacuum

2. Follow instructions on page 11 for clearing clogs

3. Dirt container full

3. Empty dirt container

4. Dirt container or upper tank not installed properly

4. Position correctly and lock in place

5. Filters are dirty

5. Check and clean pre-motor and

post-motor filters

Visible dirt escaping from cleaner

possible causes

Remedies

1. Dirt container full

1. Empty dirt container

2. Filters missing or installed incorrectly

2. Check pre-motor and post-motor filters for correct installation

cord will not retract

possible causes

Remedies

1. Knotted or twisted

1. Follow instructions on page 6

other maintenance or service not included in the manual should be

performed by an authorized service representative.

thank you for selecting a bissell product.

please do not return this product to the store.

Advertising
This manual is related to the following products: