Troubleshooting – Craftsman 247.77099 User Manual
Page 19
19
NOTE:
For repairs beyond the minor adjustments listed above, please contact your local Sears Parts & Repair
Center.
Problem
Possible Cause(s)
Corrective Action
Engine fails to start
1.
Fuel tank empty or stale fuel.
2.
Spark plug wire disconnected.
3.
Cannot pull recoil cord.
4.
Choke not in ON position.
5.
Faulty spark plug.
6.
Safety switch not depressed.
7.
Safety switch wire is not
connected to engine or not
properly grounded.
1.
Fill tank with clean, fresh gasoline. Fuel will not
last over thirty days unless a fuel stabilizer is
added.
2.
Connect wire to spark plug.
3.
Obstruction lodged in impeller. Disconnect
spark plug wire and remove lodged object.
4.
Move CHOKE to ON position.
5.
Clean, adjust gap or replace.
6.
Safety switch must be depressed by the front
tab on the bag handle when securing the bag.
7.
Connect safety switch wire to engine connector
and ground to mounting bracket.
Loss of power;
operation erratic
1.
Spark plug wire loose.
2.
Unit running on CHOKE.
3.
Blocked fuel line or stale fuel.
4.
Water or dirt in fuel system.
5.
Carburetor out of adjustment.
6.
Low engine RPM.
1.
Connect and tighten spark plug wire.
2.
Move choke lever to OFF position.
3.
Disconnect fuel line at carburetor to drain fuel
tank; fill tank with clean fresh gasoline. Fuel will
not last over thirty days unless a fuel stabilizer is
used.
4.
Disconnect fuel line at carburetor to drain fuel
tank. Refill with fresh fuel.
5.
Contact your Sears Parts & Repair Center.
6.
Always run engine at full throttle.
Too much vibration
1.
Loose parts or damaged
impeller.
1.
Stop engine immediately and disconnect spark
plug wire. Have unit serviced by a Sears Parts &
Repair Center.
Engine overheats
1.
Carburetor not adjusted
2.
Engine oil level low
1.
Contact your Sears Parts & Repair Center.
2.
Fill crankcase with proper selection of oil.
Unit does not
discharge
1.
Discharge area clogged.
2.
Foreign object lodged in
impeller.
3.
Low engine RPM.
4.
Vacuum bag is full.
1.
Stop engine immediately and disconnect spark
plug wire. Clean flail screen and inside of
discharge opening. See Maintenance section of
this manual.
2.
Stop engine immediately and disconnect spark
plug wire. Remove lodged object.
3.
Always run engine at full throttle.
4.
Empty bag.
Rate of discharge
slows considerably or
composition of
discharged material
changes
1.
Low engine RPM.
2.
Chipper blade dull.
1.
Always run engine at full throttle.
2.
Replace chipper blade or see your Sears Parts
& Repair Center.
Unit fails to propel
itself or slips when
drive control is
engaged
1.
Drive control cable out of
adjustment.
2.
Drive belt worn or damaged.
1.
Follow adjustment procedure in Service and
Adjustments section of manual.
2.
Contact your Sears Parts & Repair Center.
TROUBLESHOOTING