Edge Lighting Form Round & Square MR16 - Manual

SAVE THESE INSTRUCTIONS!
M-FOR-_
Form Round & Square Installation Instructions for
1
904-FJ-FORM-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
A
1: Use a small Allen wrench or a pen point to loosen and
remove the lens holder ring from the fixture ring.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 75 Watt, Type MR16 Front Glass Cover Halogen
Lamp.
Install the Lamp
ALLEN WRENCH
LENS HOLDER RING
FIXTURE RING
1
B
2: Place a lens or louver and the lamp into the fixture ring.
Replace and tighten the lens holder ring to fixture ring.
3: Align and push socket holes completely onto lamp pins.
LENS OR LOUVER
LAMP
LENS HOLDER RING
2
SOCKET
LAMP
PINs
M2-FOR-_
FJ-FOR-_
- This product is ETL listed for indoor dry locations.
- This product is not restricted to certain height installation.
It is approved to be used at any height above the floor.
- Applicable accessories are Hexcell Louver, Glass Lenses &
MR16 Snout.
3
FIXTURE RING
© 2009 Edge Lighting. All Rights Reserved.