Edge Lighting Function Round & Square MR16 - Manual

Use MAX 75 Watt, AR111 Halogen Lamp.
SAVE THESE INSTRUCTIONS!
M-FUN-_
Function Round & Square Installation Instructions for
1
904-FJ-FUN-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
A
1: Place the lamp into the fixture ring and secure it in place by
tightening the three #2-56 set screws with the 0.035 Allen
wrench provided.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Install the Lamp
FIXTURE RING
M2-FUN-_
FJ-FUN-_
- This product is ETL listed for indoor dry locations.
- This product is not restricted to certain height installation.
It is approved to be used at any height above the floor.
LAMP
#2-56 SET
SCREW
0.035 ALLEN WRENCH
B
2: Remove the two Phillips screws from the back of the lamp.
3: Place each Phillips screw into one fixture wire ring terminal
and connect it to back of the lamp tightly. Make sure that
the Phillips screw connection is very tight to avoid
heat buildup and corrosion.
LAMP
PHILLIPS
SCREW
RING
TERMINAL
1
1
2 2
3 3
© 2009 Edge Lighting. All Rights Reserved.