Edge Lighting Harley with Gobo User Manual
Harley with gobo holder, Install the fixture, Installation instructions for
SAVE THESE INSTRUCTIONS!
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
M-HAR-5-GO-_
FJ-HAR-5-GO-_
M2-HAR-5-GO-_
- This product is ETL listed for indoor dry locations.
- This product is not restricted to certain height installation.
It is approved to be used at any height above the floor.
- Applicable accessories are Hexcell Louver, Glass Lenses,
Gobo, and lens holder.
A
2: Place an optional optical accessary and lamp into the lamp
holder, and secure them by tightening the lens holder ring to
the lamp holder.
3: Push the socket completely onto the lamp pins.
Use
MAX
75
Watt, Type MR16 Front Glass Cover Halogen
Lamp.
CAUTION:
To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
B
Installation Instructions for
Harley with Gobo Holder
Install the Fixture
1
904-HAR-5-GO-01
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth. Oil from skin
may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT INFORMATION
© 2009 Edge Lighting. All Rights Reserved.
LENS HOLDER RING
ALLEN WRENCH
1:
remove the lens holder ring from the lamp holder.
Use a small Allen wrench or a pen point to loosen and
1
LAMP
SOCKET
LAMP HOLDER
LENS HOLDER RING
OPTICAL
ACCESSORY
LAMP
2
3