Edge Lighting Spirit - Manual

SAVE THESE INSTRUCTIONS!
M-SPI-_
FJ- -_ SPI
M2- -_ SPI
- This product is ETL listed for indoor dry locations.
- This product is not restricted to certain height installation.
It is approved to be used at any height above the floor.
- Applicable accessories are Hexcell Louver, Glass Lenses,
Little Shady Mesh Back Shade, Little Shady Round Back
Solid Shade, Little Shady Round Back Glass Shade, Large
Solid Back Shade.
Spirit 3", 6", & 12" Installation Instructions for
1
904- -03 SPIRIT
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
IMPORTANT SAFETY INSTRUCTIONS
Install the Lamp & Accessory Shade (S3-_)
A
1: Unscrew and remove the cap from the accessory shade base
(this only applies for Little Shady round back glass shade
accessory).
ACCESSORY SHADE BASE
CAP
Use MAX 50 Watt, Type MR16 Front Glass Cover Halogen
Lamp.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
B
2: Place the MR16 lamp into the accessory shade.
MR16 LAMP ACCESSORY SHADE
1
2
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
© 2009 Edge Lighting. All Rights Reserved.