Edge Lighting 2 Circuit Feed-End Power Feed Canopies User Manual
For new construction, Monorail 2 circuit 4" round feed-end power canopy, Installation instructions for
SAVE THESE INSTRUCTIONS!
M2P-4RD-FE-_
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- This product should be installed by a qualified electrician.
Installation Instructions for
Monorail 2 Circuit 4" Round Feed-End Power
Canopy
1
904-M2P-4RD-FE-04
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
For New Construction
A
CEILING DRYWALL
JOIST
STUD
CEILING
FRAME STUD
A
6"
ELECTRICAL BOX
1: For Double Ceiling Frame Stud, use the Monorail 2
Circuit 6" standoff to mount the Feed-End Power Canopy
closest to the ceiling. Refer to the chart below to determine
the 4" electrical box distance from the ceiling frame stud.
DRY WALL
THICKNESS
A
1/2"
1.79"
5/8"
1.92"
3/4"
2.04"
B
CEILING DRYWALL
JOIST
STUD
CEILING
FRAME STUD
A
3"
ELECTRICAL BOX
2: For Single Ceiling Frame Stud, use the Monorail 2 Circuit
6" standoff. Cut 3" off of the standoff rod, to mount the
Feed-End Power Canopy closest to the ceiling. Refer to the
chart below to determine the 4" electrical box distance from
the ceiling frame stud.
DRY WALL
THICKNESS
A
1/2"
0.33"
5/8"
0.45"
3/4"
0.57"
© 2009 Edge Lighting. All Rights Reserved.