Edge Lighting 2 Circuit Straight Rail - Manual

M2-24-_
- This product is ETL listed for indoor dry locations.
- Monorail 2 Circuit is bendable horizontally to a radius as
small as 12". The Monorail 2 Circuit cannot be bent
vertically in the field.
- The product is intended to be used with Edge Lighting
Monorail 2 Circuit systems only.
A
Monorail 2 Circuit 24", 48", & 96"
Installation Instructions for
Bend the Monorail 2 Circuit
1
904-M2-96-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
NOTE: Bend the Monorail 2 Circuit horizontally only. Monorail 2
Circuit cannot be bent vertically in the field. Vertically bending the
Monorail 2 Circuit in the field will damage the Monorail 2 Circuit
and will separate the rails from the insulator.
M2-48-_
M2-96-_
VERTICAL BENDING
FRONT OF
THE MONORAIL
2 CIRCUIT
HORIZONTAL BENDING
B
MONORAIL 2 CIRCUIT
CIRCULAR
PLYWOOD
1
4
1: Determine the radius of the curve or circle.
2: Draw the curve on plywood and cut out the pattern from the
plywood.
3: Secure the plywood in place.
4: Hold one edge of the Monorail 2 Circuit against the plywood.
Start bending the Monorail 2 Circuit against the plywood
until the desired curve or circle is achieved.
SAVE THESE INSTRUCTIONS!
TOP OF THE
MONORAIL
2 CIRCUIT
NOTE: Do not straighten the bent Monorail 2 Circuit which will
cause the rails to separate from the insulator.
© 2009 Edge Lighting. All Rights Reserved.