Edge Lighting 150W/12V Recessed Mount Electronic Transformer - Manual

SAVE THESE INSTRUCTIONS!
MTE-RC-150-12-_
- This product is ETL listed for indoor dry locations.
- This product is intended for use with Edge Lighting low
voltage lighting systems only.
- This product may be dimmed only with a low voltage
electronic dimmer. Using a dimmer other than specified
may work initially, but will eventually cause transformer
failure and void the warranty. The dimmer must be derated
as indicated by the dimmer manufacturer.
- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.
- The Monorail recessed can transformer can be used with
the following down lights: Juno IC2, TC2, and TC2R; Halo
H7T and H7RT; Cooper lighting H27RT, Capri (Thomas)
Lighting PR75ASIC/TPR75ASIC/DY6431; Progress Lighting
P7TG, P8-TG and PIO8-TG. Edge Lighting is not affiliated
with, nor is it endorsed by, any of the companies listed
above.
Installation Instructions for
Transformer 120 Volt Input to 12 Volt Single Feed Output
Monorail 150 Watt Recessed Can Electronic
1
904-MTE-RC-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
- Do not install this lighting system in a damp or wet
location.
- Do not conceal or extend bus bar conductor through
building wall.
- To reduce the risk of fire and burns, do not install this
lighting system where the insulated open bus bar
conductors can be shorted or contact any conductive
materials.
- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
- Do not install fixture assemblies closer than six inches, or
as specified in the fixture installation instructions, to
curtains or similarly combustible materials.
- Turn the electrical power off before modifying the lighting
system in any way.
- The fixtures used with the Edge Lighting systems must be
identified for use with the corresponding Edge Lighting
systems.
- Minimum volume of the electrical box must be 6 cubic
inches (98 cubic centimeters).
- The system is "ETL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.
IMPORTANT SAFETY INSTRUCTIONS
© 2009 Edge Lighting. All Rights Reserved.