Edge Lighting PSB-100W-ELV-24VDC, 96 Watt 24 Volt DC Power Supply User Manual

Install the power supply, Installation instructions for, General information important safety instructions

Advertising
background image

Installation Instructions for

24 Volt 100 Watt DC Power Supply

PSB-100W-ELV-24VDC-01

SAVE THESE INSTRUCTIONS!

- Do not install this power supply in a wet location.

- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.

- Do not install *LED fixture closer than three inches or as
specified in the *LED fixture installation instructions to
curtains or similarly combustible materials. Keep insulation
at least 3" away from the enclosure.

- Turn the electrical power off before modifying the lighting
system in any way.

* See LED fixture installation instructions for proper
placement.

- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions "
before installation.

- This product is not suitable for wet locations. It is approved
for the use at any height above the finished floor.

- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.

- TO REDUCE RISK OF FIRE, it is important to wire the
power supply for the system as described in this
installation instruction.

GENERAL INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

Install the Power supply

A

1: Loosen the four Phillips screws on the side of
the power supply to remove the cover.

2: Secure the power supply case to the desired location with
the two #6 screws provided.

PHILLIPS
SCREW

COVER

1

3: Install a conduit and 120 VAC power wires from the panel to
the power supply.

4: DO NOT connect the power wires to the panel at this time.

5: Ground the power supply housing in accordance with local
electrical codes.

6: Connect the 120 Volt hot black wire to the black wire coming
from the transformer with a wire nut.

7: Connect the 120 Volt neutral wire to the white wire coming
from the transformer with a wire nut.

#6 SCREW

2

7

6

2

120 VAC NEU

120 VAC HOT

CONDUIT

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

© 2014 Edge Lighting. All Rights Reserved.

Advertising