Edge Lighting PSB-2X96W-010-24VDC, 192(2x96) Watt 24 Volt DC Power Supply - Manual

Installation Instructions for 2 X 96 Watt 24 Volt DC Power Supply with
0-10 Volt Dimming Module
1
PSB-2X96W-010-24VDC-03
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
SAVE THESE INSTRUCTIONS!
- Do not install this power supply in a wet location.
- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
- Do not install *LED fixture closer than three inches or as
specified in the *LED fixture installation instructions to
curtains or similarly combustible materials. Keep insulation
at least 3" away from the enclosure.
- Turn the electrical power off before modifying the lighting
system in any way.
- The system is "ETL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.
* See LED fixture installation instructions for proper
placement.
- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions"
before installation.
- This product is not suitable for wet locations. It is approved
for the use at any height above the finished floor.
- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.
- TO REDUCE RISK OF FIRE, it is important to wire the
power supply for the system as described in this
installation instruction.
- Load each power supply to MAXIMUM 96 Watts.
- Use Lightolier "ZP600FAM120" 0-10 volt controller to dim
the LED soft strip (fixture).
GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS
© 2014 Edge Lighting. All Rights Reserved.