Edge Lighting Rocky Ceiling - Manual

Installation Instructions for Rocky Ceiling MR16 Version
904-ROC-C-H1-04
Install the Fixture
1
ROC-C-H1-_ 1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
A
1: Loosen the M4 set screw (DO NOT REMOVE) on the metal
shade with the 2MM Allen wrench provided, and pull the
metal shade completely off of the canopy.
METAL SHADE
CANOPY
1
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor and outdoor locations.
- This product is for ceiling mount applications only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard electronic
low voltage dimmer.
- This instruction shows a typical installation for indoor or
outdoor applications.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
M4 SET SCREW
2MM ALLEN
WRENCH
B
2: Connect the white transformer wire to the neutral power
wire with a wire nut.
3: Connect the black transformer wire to the hot power wire
with a wire nut.
4: Place the transformer and wire nut connections inside the
electrical box.
TRANSFORMER WIRE NUT
ELECTRICAL BOX
3
2
4
© 2010 Edge Lighting. All Rights Reserved.
#8-32 SCREW
C
ELECTRICAL
BOX THREADED
HOLE
CROSSBAR
5
6
5:
6:
the provided #8-32 screws.
Feed the transformer wires through the crossbar center hole.
Mount the crossbar to the electrical box threaded holes with
6