Edge Lighting Plaza Small Dimmable - Manual (Page 2)

G N L
G N L
G N L
G N L
2
D
8: Feed the power wires through the mounting plate center
hole and slide the mounting plate onto the nipple.
9: Secure the mounting plate to the crossbar assembly by
tightening the nut and lock washer. Make sure that the
mounting plate holes line up with the anchors.
NUT
9
LOCK WASHER
6: Use a 9/32 drill bit to make holes on all six marked points.
7: Tap the anchors into the drilled holes with a hammer.
C
WALL
6
ANCHOR
9/32 DRILL BIT
7
7
E
10: Level the mounting bracket horizontally and use the #8
screws to secure the mounting plate to the anchors.
8
#8 SCREW
NIPPLE
10
MOUNTING
PLATE