Edge Lighting Greta - Manual

SAVE THESE INSTRUCTIONS!
GRETA-W-_-H1-_
M2-IND-_
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only, either vertically or
horizontally.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
Installation Instructions for
Greta
904-GRETA-W-H1-08
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
1
© 2012 Edge Lighting. All Rights Reserved.
OFF-CENTER MOUNT INSTALLATION
CENTER MOUNT INSTALLATION
Disassemble the Fixture
A
SCREW HEAD
SLOT
1: Remove the Phillips screw on the top of the glass shade and
slide the glass shade up to remove it from the backplate. PHILLIPS SCREW
1
1
GLASS SHADE
BACKPLATE
B
2:
detach the socket plate from the backplate. Remove the four thumb nuts from the threaded studs to 2
THUMB NUT
THREADED
STUD
BACKPLATE
SOCKET PLATE
THUMB
NUT
THREADED
STUD
2