Edge Lighting Regal - Manual

SAVE THESE INSTRUCTIONS!
REGAL-H1-_
M2-IND-_
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
Installation Instructions for
Regal (Halogen Version)
904-REGAL-H1-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
IMPORTANT SAFETY INSTRUCTIONS
Install the Fixture
1:
body to detach the cover. Remove the two thumb screws on the sides of the fixture
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
1
A
© 2009 Edge Lighting. All Rights Reserved.
THUMB SCREW
1
COVER
FIXTURE BODY
1
B
2: Squeeze the spring ends and remove them from the inner
bracket.
3: Pull the reflector out.
SPRING
CLIP
REFLECTOR
FIXTURE
SPRING CLIP
3
2
3
INNER
BRACKET