Edge Lighting Cirrus Channel, Square 1" Lens - Manual

Installation Instructions for Cirrus Channel, Square 1" Lens
904-CC-S1-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
1
CC-S1-_
A
ELECTRICAL BOX
Install the Junction Box (C-1RE-JBOX)
MOUNTING
BRACKET
1
electrical box (mounts to any side of the housing depending
on the orientation of the channel) and secure them with the
mounting brackets and two Phillips screws provided. : Mount each adjustable mounting bar to one side of the
2:
box to be mounted.
3: Place the adjustable mounting bars between the studs.
4: Make sure the lips on the adjustable mounting bars are
against the studs. Secure the adjustable bars to the
studs with the eight #8 screws.
Select the location between the two studs for the electrical
NOTE: The adjustable mounting bars mount to studs that are
spaced 16" to 24" apart.
STUD
ADJUSTABLE
MOUNTING BAR
#8 SCREW
ADJUSTABLE
MOUNTING BAR
PHILLIPS SCREW
B
C
5: Remove a knockout to install the power line conduit.
6: Install the conduit and run the low voltage 24V DC power
wires coming from the remote power supply to the
electrical box.
7: Refer to the instruction provided with the power supply to
properly wiring diagram.
1
2
4
4
4
4
STUD
ADJUSTABLE
MOUNTING BAR
CONDUIT
6
5
ELECTRICAL
BOX
ELECTRICAL
BOX
NOTE: Prior to installing the Cirrus Channel, junction box
must be installed. If using Edge Lighting Slim Profile
junction box (C-1RE-JBOX) follow steps "Install the
Junction Box (C-1RE-JBOX) " below, if using a standard
junction box, continue on to steps "Install the Cirrus
Channel" on page 2.