Edge Lighting Miniport LED Components - Manual

Installation Instructions for Miniport Round & Round Eye Lid LED
904-MPORT-12VAC-02
- This product is ETL listed for indoor wet locations.
- WARNING: Fixture must be installed in accordance with
National and Local Electrical codes.
- Load cannot exceed the total wattage of the LED power
supply rating.
- This fixture must be installed by a licensed electrician.
- Use UL listed type UF underground cable when no conduit
is used to power the fixture(s).
- For outdoor installation, use outdoor rated electrical
boxes (minimum 1.5" deep), conduit feedings, and wire
nuts. For indoor installation use octagon electrical boxes.
- This instruction shows a typical installation.
IMPORTANT SAFETY INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
MPORT-12VAC-_-SS
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
- Miniports are only powered by a 12VAC LED transformer
and are dimmable with an Electronic Low Voltage
Dimmer.
1
Outdoor Installation Using a LED Single Power Supply (TE-60L-12)
OUTDOOR
ELECTRICAL BOX
CONDUIT GOING TO
ELECTRICAL PANEL
BUILDING WALL
1
3
1: Install an outdoor electrical box onto the wall or post next to
the building to fit the LED power supply (TE-60L-12) and to
branch the power to all in ground electrical boxes
2: Install conduit and run 120 volt power wires from the panel
to the outdoor box.
3: Install conduit(s) from the outdoor electrical box to all in
ground fixture outdoor electrical boxes.
4: Run proper wire sizes from branching electrical box to all
fixture electrical boxes using the "Wire Size Chart" on page 3.
GROUND
A
2
120VAC
2.97"
1.5"
1.47" 12VAC
NOTE:
maximum of 45 Mini Port fixtures.
The TE-60L-12 electronic LED power supply can power
B
5
6
7
7
8
5: Connect the white LED power supply wire to 120 volt neutral
power wire with a wire nut.
6: Connect the black LED power supply wire to 120 volt hot
power wire with a wire nut.
7: Connect one 12 volt power supply (red wire) in parallel to
one wire going to each fixture electrical box with wire nuts.
Connect the other 12 volt power supply wire in parallel to the
other wire going to each fixture electrical box with wire nuts.
(See wiring diagram on page 4).
8: Place the LED power supply and wire nut connection inside
the electrical box and mount the box cover.
120 VOLT
WIRES (INPUT)
12 VOLT
WIRES (OUTPUT)