Edge Lighting Sun 3 LED Components - Manual

Installation Instructions for Sun 3 Round & Square LED
904-SUN3-03
- WARNING: Fixture must be installed in accordance with
National and Local Electrical codes.
- Load cannot exceed the total wattage of the transformer
rating.
- This fixture must be installed by a licensed electrician.
- Use UL listed type UF underground cable when no conduit
is used to power the fixture(s).
- For outdoor installation, use outdoor rated electrical
boxes (minimum 1.5" deep), conduit feedings, and wire
nuts. For indoor installation use octagon electrical boxes.
IMPORTANT SAFETY INFORMATION
Outdoor Installation Using an Electronic LED Power Supply (TE-60L-12)
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
OUTDOOR
ELECTRICAL BOX
CONDUIT GOING TO
ELECTRICAL PANEL
BUILDING WALL
1
3
© 2012 Edge Lighting. All Rights Reserved.
1: Install an outdoor electrical box onto the wall or post next to
the building to fit the LED power supply (TE-60L-12) and to
branch the power to all in ground electrical boxes
2: Install conduit and run 120 volt power wires from the panel
to the outdoor box.
3: Install conduit(s) from the outdoor electrical box to all in
ground fixture outdoor electrical boxes.
4: Run proper wire sizes from branching electrical box to all
fixture electrical boxes using the "Wire Size Chart" on page 6.
GROUND
A
4"
4
NOTE:
maximum of 4 Sun 3 fixtures.
The TE-60L-12 electronic LED power supply can power
B
5
6
7
7
8
5: Connect the white LED power supply wire to 120 volt neutral
power wire with a wire nut.
6: Connect the black LED power supply wire to 120 volt hot
power wire with a wire nut.
7: Connect one 12 volt power supply (red wire) in parallel to
one wire going to each fixture electrical box with wire nuts.
Connect the other 12 volt power supply wire in parallel to the
other wire going to each fixture electrical box with wire nuts.
(See wiring diagram on page 6).
8: Place the LED power supply and wire nut connection inside
the electrical box and mount the box cover.
SUN3-HD_-_-WW-SA
NOTE:
fixture omit the steps below and refer to the "Outdoor Installation
Using Magnetic Remote Transformer" section.
If using a magnetic remote transformer to power the
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
- This fixture must be powered with a 12 VAC magnetic
remote transformer (T-150-12, or T-300-12) or an LED
electronic power supply (TE-60L-12) only.
- For optical controls such as 20° beam tilt, micro louver or
glass lens use SUN3-LL accessory (sold separately).
- When dimming use a magnetic low voltage dimmer with a
magnetic remote transformers and electronic low voltage
dimmer with an electronic transformer.
1
2
1.6"
2.4"
120VAC
12VAC
120 VOLT
WIRES (INPUT)
12 VOLT
WIRES (OUTPUT)