Edge Lighting Vision 3 User Manual
Vision 3 halogen kit, Install the vision housing, Installation instructions for
Installation Instructions for
Vision 3 Halogen Kit
904-VISION3-KIT-H1-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
Install the Vision Housing
1
© 2010 Edge Lighting. All Rights Reserved.
VISION3-KIT-H1-_
1:
mounted.
2: Place the plaster screen in front of the housing so that the
folded lips face outside.
3: Line up the screw holes on the plaster screen with the screw
holes of the housing and place one housing lip against the
marked stud.
4: Secure the housing along with the plaster screen to the stud
with the provided three #8 screws.
5: Use the other three #8 screws to secure the plaster screen
to the housing.
Mark the location on the stud where the housing will be
NOTE:
One of the housing lips needs to be installed to the
nearest stud of the desired location.
A
STUD
#8 SCREW
1
PLASTER
SCREEN
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- This product can be dimmed with an electronic low voltage
dimmer.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
HOUSING LIP
3
4
FOLDED LIP
5