Edge Lighting PSB-100W-24VDC-RGB, 100 Watt 24 Volt DC Power Supply - Manual

Installation Instructions for 100 Watt 24 Volt DC RGB DMX
LED Power Supply
1
PSB-100-24VDC-RGB-02
SAVE THESE INSTRUCTIONS!
- Do not install this power supply in a wet location.
- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
- Do not install *LED fixture closer than three inches or as
specified in the *LED fixture installation instructions to
curtains or similarly combustible materials. Keep insulation
at least 3" away from the enclosure.
- Turn the electrical power off before modifying the lighting
system in any way.
- The system is "ETL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.
* See LED fixture installation instructions for proper
placement.
- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions "
before installation.
- This product is not suitable for wet locations. It is approved
for the use at any height above the finished floor.
- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.
- TO REDUCE RISK OF FIRE, it is important to wire the
power supply for the system as described in this
installation instruction.
- Load the power supply to MAXIMUM 100 Watts.
- Use CDP color dial or CTP color touch screen controller with
RGB LED soft strip.
GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS
VOLTAGE
DROP
UP TO 31FT
3%
32FT-49FT
WIRE SIZE
VOLTAGE AT END
OF THE WIRE
14 AWG
23.28 VAC
50FT-81FT 82FT-124FT
12 AWG
23.29 VAC
10 AWG 8 AWG
23.28 VAC 23.28 VAC
WIRE LENGTH
IN FT
100W, 24VAC LOW VOLTAGE WIRE SIZE CHART
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2014 Edge Lighting. All Rights Reserved.