Edge Lighting Soft Strip Cove Square System - Manual

Installation Instructions for
Soft Strip Cove
904-SCO-01
Install the Soft Strip Cove
1
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
SCO-_
0.62"
2.5"
0.5"
0.28"
Soft Strip Cove Dimensions
A
WALL
1: Mark the key hole locations of the Soft Strip Cove on a
straight line where the Soft Strip Cove is going to be
installed.
NOTE: Two people are required if the Soft Strip Cove is used as a
template to mark the installation holes.
NOTE: Prior to Soft Strip Cove installation the low voltage wires
should be present. Refer to the instructions provided with the
power supply to install the low voltage wires before proceeding
with the steps below.
SOFT STRIP COVE
LOW VOLTAGE
WIRE
MOUNTING
HOLE
1
1
B
2: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
3: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
WALL
2
3
ANCHOR
NOTE:
mounting the Soft Strip Cove to a wood surface directly.
Steps 2 to 3 are for drywall mounting. Omit these steps if