Edge Lighting Canopy Cover & Splice Box - Manual

SAVE THESE INSTRUCTIONS!
3RE-WH
- This product is ETL listed for indoor dry locations.
- This product can only be installed to a 4.5" X 2.5"
rectangle electrical box (gangbox).
Installation Instructions for 3" Rectangle Canopy Cover
1
904-3RE-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2011 Edge Lighting. All Rights Reserved.
A
1: Feed the soft strip power wires through the canopy center
hole.
2: Snap the cap onto the canopy center hole and the soft strip
wires.
Install the Canopy Cover
B
1
NOTE: The low voltage DC power supply wires should be present
in the electrical box before proceeding with the steps below. Refer
to the power supply instructions for more details.
SOFT STRIP
WIRE
CANOPY
2
CAP
3: Connect the black and red soft strip power wires to the black
and red transformer wires respectively with wire nuts.
3
3
C
#8-32 SCREW
CANOPY
LOW VOLTAGE
WIRE
5 5
6
CANOPY
SOFT STRIP
WIRE
ELECTRICAL
BOX
SOFT STRIP
WIRE
TRANSFORMER WIRES
4: Place all wire and wire nut connections inside the electrical
box.
5: Secure the canopy to the electrical box with the two #8-32
provided screws.
6: Refer to the instructions provided with the soft strip to
connect the power to soft strip.
4