Edge Lighting Micro Switch - Manual (Page 2)

2
Install the Micro Switch
1: Insert the soft strip wire connected to the "+ DC" side of the
strip into the terminal connector and use the crimper on the
cylindrical portion of the terminal connector to secure the
wire.
2: Connect the other soft strip wire connected to the "- DC"
side of the strip to the black power supply wire marked "-
DC" with a wire nut.
3: Connect the red wire marked "+ DC" into the
other terminal connector and use the crimper on the
cylindrical portion of the terminal connector to secure the
wire.
power supply
A
NOTE: The soft strip LED and power supply should be installed
prior to these steps.
B
SOFT STRIP LED
SWITCH
POWER SUPPLY
4
4: Insert each terminal connector onto one switch prong.
SOFT STRIP LED
12V DC
+
-
+
POWER SUPPLY
120V
-
2
1
3
TERMINAL CONNECTOR
SWITCH
SCREW
5
DRAWER
INSTALLATION
DRAWER
C
SWITCH
CABINET
SWITCH
SCREW
NOTE: For best results install the switch as close as possible to
the cabinet door hinge or drawer, (shown in drawing C).
5: Properly align the switch position with the cabinet door or
drawer and secure it in place with the provided phillips
screws.
5
CABINET
INSTALLATION
12V DC