Edge Lighting Dot LED - Manual (Page 2)

2
Power the Dot Lights
1: Mark the location where the hub is going to be installed.
2: Use a 1/16" drill bit to drill pilot holes on marked locations.
3: Mount the hub to the pilot holes with the three Phillips
screws provided.
4: Connect the AC Power cord into the single port of the hub.
5: Connect each LED Dot AC cord into one port.
6: Use the provided clips to manage the Dots and Hub cords.
7: Connect the Hub AC power cord to the 12 volt power supply
wires. Refer to the instructions provided with the power
supply.
C
CLIP
CORD 6
HUB
3
TYPICAL WIRING DIAGRAM
PHILLIPS
SCREW
3
DOT LED AC CORD
4 5
NOTE:
watt.
Each Dot contains a 1 watt LED consuming a total of 1
AC POWER CORD
POWER
SUPPLY
HUB
7
WHITE(NEUTRAL)
RECTANGLE
ELECTRICAL BOX
HUB-4P
BLACK (HOT)
120VAC
ELECTRONIC LOW VOLTAGE
DIMMER OR SWITCH
TE-60L-12AC-3RE-WH
RECTANGLE
CANOPY COVER
(3RE-WH)
TE-60L-12AC
6FT
12VAC
DOT LED CABINET LIGHTING.
1W PER FIXTURE
EDGE # DOT-RD-1W-30D-30K-SA
DOT-RD-1W-90D-30K-SA
DOT-SQ-1W-30D-30K-SA
3FT
12VAC