Digital compass – BMW X6 xDrive50i 2011 User Manual
Page 127
![background image](/manuals/601877/127/background.png)
125
The corresponding memory button
1 is now
programmed with the signal of the original
hand-held transmitter.
You can operate the device when the engine is
running or when the ignition is switched on.
If the device cannot be used after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the
instructions for the original hand-held transmit-
ter or hold down the programmed memory
button
1 of the integrated universal remote
control. If the LED
2 on the integrated universal
remote control flashes rapidly for a short time
and then remains lit for approx. 2 seconds, this
indicates that the original hand-held transmitter
uses an alternating-code system. In the case of
an alternating-code system, program the mem-
ory buttons
1 as described at Alternating-code
hand-held transmitters.
<
Alternating-code hand-held
transmitters
To program the integrated universal remote
control, consult the operating instructions for
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters
that employ an alternating code, observe the
following supplementary instructions:
Programming will be easier with the aid of
a second person.
<
1.
Park your vehicle within the range of the
remote-controlled device.
2.
Program the integrated universal remote
control as described above in the section
Fixed-code hand-held transmitters.
3.
Locate the button on the receiver of the
device to be set, e.g. on the drive unit.
4.
Press the button on the receiver of the
device to be set. After step 4, you have
approx. 30 seconds for step 5.
5.
Press the programmed memory button
1
of the integrated universal remote control
three times.
The corresponding memory button
1 is now
programmed with the signal of the original
hand-held transmitter.
Should you have questions, please con-
tact your BMW Sports Activity Vehicle
Center.
<
Deleting all stored programs
Press the left and right-hand memory button
1
for approx. 20 seconds until the LED
2 flashes
quickly:
All stored programs are deleted.
Reassigning individual programs
1.
Hold the original hand-held transmitter at a
distance of approx. 4 in/10 cm to 12 in/
30 cm from the memory buttons
1.
The required distance between the
hand-held transmitter and the mem-
ory buttons
1 depends on the relevant sys-
tem of the original hand-held transmitter
used.
<
2.
Press the desired memory button
1 of the
integrated universal remote control.
3.
When the LED
2 flashes slowly after approx.
20 seconds, press the transmit button of
the original hand-held transmitter. Release
both buttons as soon as the LED
2 flashes
rapidly. If the LED
2 does not flash rapidly
after approx. 15 seconds, alter the distance
and repeat the step.
Digital compass*
1 Adjustment button
2 Display
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG
Online Edition for Part no. 01 41 2 604 009 - © 03/10 BMW AG