FORD 2015 F-550 v.2 - Manual (Page 56)

Note: You can clear or change your MyKey
settings at any time during the same key
cycle as you created the MyKey. Once you
have switched the engine off, however, you
will need an admin key to change or clear
your MyKey settings.
CLEARING ALL MYKEYS
You can clear all MyKeys within the same
key cycle as you created the MyKey. If you
switch your ignition off, however, you will
need to use an admin key to clear your
MyKeys.
Note: When you clear your MyKeys, you
remove all restrictions and return all MyKeys
to their original admin key status at once.
To clear all MyKeys of all MyKey settings,
use the information display. There are two
types of information displays, and their
controls and messaging vary. To determine
which type of display you have, you will
need to reference another chapter. See
General Information (page 83).
If You Have a Type 1 Information
Display:
1. Press SETUP until PRESS RESET TO
CLEAR MYKEY displays.
2. Press and release the RESET button.
The display will show HOLD RESET
TO CONFIRM CLEAR.
3. Press and hold the RESET button for
two seconds until ALL MYKEYS
CLEARED displays.
If You Have a Type 2 Information
Display:
1. Access the main menu and select
SETTINGS, then MYKEY.
2. Scroll to CLEAR ALL and press the OK
button.
3. Hold the OK button until ALL
MYKEYS CLEARED displays.
CHECKING MYKEY SYSTEM
STATUS
You can find information on programmed
MyKey(s) using the information display
control on the steering wheel. See
Information Displays (page 83).
To find information on a programed MyKey(s), press the left arrow button to
access the main menu and scroll to:
Description Message
Press the OK button. Settings
Press the OK button. MyKey
Select one of the following:
53
Super Duty (), enUSA
MyKey™