FORD 2014 Flex v.1 - Manual (Page 153)

Recalling a memory position
You can recall a programmed memory position:
• in any gearshift position if the ignition is not on.
• only in position P or N if the ignition is on.
Press the desired memory control to recall a memory position.
Recalling memory positions with the remote control
You can recall the memory positions when you press unlock on your
remote control (if the transmitter is programmed to a memory position)
or, when you enter a valid personal entry code that is programmed to a
memory position. If you enable the easy entry feature, the seat will first
move to the easy entry position. The seat will move to the final position
when the key is in the ignition or when the push button start system (if
equipped) is put in accessory mode or started.
To program the memory feature to a remote control, see the Keys and
Remote Control chapter.
Easy Entry and Exit Feature (If Equipped)
This feature can move the seat rearward and the steering column up and
forward to allow extra room to exit the vehicle.
This occurs when:
• the transmission selector lever is in position N or P
• the key is removed from the ignition or the push button start system
is switched off.
The seat and steering wheel will move to their original positions when:
• the transmission selector lever is in position N or P
• the key is placed in the ignition or when the push button start system
is put in accessory mode or started.
Turn the easy entry feature off or on through the information display.
See the Information Displays chapter.
152 Seats
2014 Flex (471)
Owners Guide gf, 1st Printing, April 2013
USA (fus)