Hazard warning flashers, Fuel shutoff, Jump-starting the vehicle – FORD 2013 Fusion v.3 User Manual

Page 231: Roadside emergencies

Advertising
background image

Canadian customers who need to obtain
roadside information, call
1-800-665-2006 or visit our website at
www.ford.ca.

HAZARD WARNING FLASHERS

Note: If used when the engine is not
running, the battery will lose charge. There
may be insufficient power to restart your
engine.

The hazard warning button is
located on the instrument panel.
Use it when your vehicle is

creating a safety hazard for other
motorists.

Press the button to turn on the hazard
warning function, and the front and
rear direction indicators will flash.

Press the button again to turn them
off.

FUEL SHUTOFF

WARNING

Failure to inspect and, if necessary,
repair fuel leaks after a collision may
increase the risk of fire and serious

injury. Ford Motor Company recommends
that the fuel system be inspected by an
authorized dealer after any collision.

In the event of a moderate to severe
collision, this vehicle is equipped with a
fuel pump shut-off feature that stops the
flow of fuel to the engine. Not every impact
will cause a shut-off.

Should your vehicle shut off after a
collision, you may restart your vehicle by
doing the following:

1.

Turn the ignition off.

2. Turn the ignition to crank.

3. Turn the ignition off.

4. Turn the ignition on again to re-enable

the fuel pump.

For vehicles equipped with a push button
start system:

1.

Press the START/STOP button to
turn the ignition off.

2. Press the brake pedal and press the

START/STOP button (crank
attempt).

3. Remove your foot from the brake pedal

and press the START/STOP button
(ignition off).

4. Press the START/STOP button again

to re-enable the fuel system.

JUMP-STARTING THE VEHICLE

WARNINGS

The gases around the battery can
explode if exposed to flames, sparks,
or lit cigarettes. An explosion could

result in injury or vehicle damage.

Batteries contain sulfuric acid which
can burn skin, eyes and clothing, if
contacted.

Use only an adequate-sized cable
with insulated clamps.

Preparing Your Vehicle

Note: Do not attempt to push-start your
automatic transmission vehicle. Automatic
transmissions do not have push-start
capability. Attempting to push-start a
vehicle with an automatic transmission may
cause transmission damage.

Note: Use only a 12-volt supply to start your
vehicle.

Note: Do not disconnect the battery of the
disabled vehicle as this could damage the
vehicle's electrical system.

228

Fusion/Mondeo (CC7)

Roadside Emergencies

Advertising