Changing the air filter element, Vehicle storage, Maintenance and specifications – FORD 2012 Fiesta v.2 User Manual

Page 318

Advertising
background image

Changing the air filter element

1. Remove the four screws that
secure the air filter housing cover.

2. Carefully separate the two halves
of the air filter housing.

3. Remove the air filter element
from the air filter housing.

4. Wipe the air filter housing and
cover clean to remove any dirt or
debris and to ensure good sealing.

5. Install a new air filter element. Be
careful not to crimp the filter element edges between the air filter
housing and cover. This could cause filter damage and allow unfiltered
air to enter the engine if not properly seated.

6. Replace the air filter housing cover and install the screws.

Note: Failure to use the correct air filter element may result in severe
engine damage. The customer warranty may be void for any damage to
the engine if the correct air filter element is not used.

VEHICLE STORAGE

If you plan on storing your vehicle for an extended period of time
(30 days or more), refer to the following maintenance recommendations
to ensure your vehicle stays in good operating condition.

All motor vehicles and their components were engineered and tested for
reliable, regular driving. Long term storage under various conditions may
lead to component degradation or failure unless specific precautions are
taken to preserve the components.

General
• Store all vehicles in a dry, ventilated place.
• Protect from sunlight, if possible.
• If vehicles are stored outside, they require regular maintenance to

protect against rust and damage.

Body
• Wash vehicle thoroughly to remove dirt, grease, oil, tar or mud from

exterior surfaces, rear-wheel housing and underside of front fenders.
See the Cleaning chapter for more information.

• Periodically wash vehicles stored in exposed locations.

Maintenance and Specifications

318

2012 Fiesta (fie)
Owners Guide, 2nd Printing
USA
(fus)

Advertising